Linen press: George II oyster veneer walnut with brass handles, c1720s. Height 81.10 in., width 44.49 in., depth 20.87 in.
- George Ii - George II (1683 - 1760) was King of Great Britain and Ireland from 1727 until his death in 1760.
- Oyster Veneer - "Oyster veneer" is a method of veneering occasionally used on antique furniture pieces. It refers to the use of thin, delicate sheets of wood that were cut from the growth rings of a tree to create a decorative pattern that resembles the texture and appearance of an oyster shell.
To create oyster veneer, the woodworker would carefully cut slices of the wood at a slight angle to the grain, so that the annual rings would be visible on the surface of the veneer. The resulting pattern looks similar to the swirling, irregular lines on the surface of an oyster shell, which is where the name comes from.
Oyster veneer was used to embellish high-end antique furniture pieces, such as cabinets, desks, and tables during the 18th and 19th centuries.
- Veneers - Veneers are thin sheets of well-figured timber that are glued under pressure to the surface of a cheaper timber for decorative effect, and then used in the making of carcase furniture.
Early veneers were saw-cut so were relatively thick, (up to 2 mm) but is was realised that saw cutting was wasteful, as timber to the equivilent of the thickness of the saw was lot on each cut.
A more efficient method was devised to slice the timber, either horizontally with a knife, or in a rotary lathe.
Flame veneer, commonly found in mahogany or cedar furniture, is cut from the junction of the branches and main trunk. So-called fiddleback veneers, where the grain is crossed by a series of pronounced darker lines, is usually cut from the outer sections of the tree trunk.
During the 17th and 18th centuries, and in much of the walnut marquetry furniture made during the latter part of the 19th century, the veneer was laid in quarters, each of the same grain, so that one half of the surface was the mirror image of the other.
The use of veneer allows many other decorative effects to be employed, including stringing, feather banding, cross banding, and inlaid decorative panels in the piece. The carcase over which veneer is laid is usually of cheaper timber such as pine, oak or, sometimes in Australia during the first half of the 19th century, red cedar.
The important thing to remember about veneers is that prior to about 1850 they were cut by hand, and were consequently quite thick - ranging up to about 2mm deep.
From the mid-19th century veneers were cut by machines and were almost wafer-thin. This is a critical point when trying to judge the approximate age of veneered furniture.
This item has been included into following indexes: